Short update.

Found a local young man who loves to weld. Bruce from Biggdaddy Steelworks came over to the BOSS427 Garage and welded up my Breeze stainless roll bars for me. They look great, and will be even better when they are all polished up. Didn’t take long, didn’t cost much and he did a great job. Look him up if you need some welding done.

While he was doing that, I couldn’t work on the car so I turned to my left and started assembling some of the components to my engine. Installed the Edelbrock AirGap RPM manifold, Pertronix Ignitor III distributor, Canton billet thermostat housing. Started the test fit on the Gas-N Stainless headers, but that’s going to require a bit of hole stretching.

Back at it tomorrow…